### Main
-zuerst:
+zuerst:
[[!format txt """
sudo aptitude install clamav spamassassin spamc greylistd
adduser clamav Debian-exim
adduser Debian-exim clamav
"""]]
-/etc/clamav/clamd.conf
+/etc/clamav/clamd.conf
[[!format txt """
#Automatically Generated by clamav-base postinst
#To reconfigure clamd run #dpkg-reconfigure clamav-base
ScanHTML
ArchiveBlockMax
"""]]
-/etc/exim4/conf.d/main/02_exim4-config_options
+/etc/exim4/conf.d/main/02_exim4-config_options
[[!format txt """
### main/02_exim4-config_options
#################################
...
"""]]
-/etc/exim4/conf.d/acl/30_exim4-config_check_rcpt
+/etc/exim4/conf.d/acl/30_exim4-config_check_rcpt
[[!format txt """
# This access control list is used for every RCPT command in an incoming
# SMTP message. The tests are run in order until the address is either
# !verify = sender
# Warn if the sender host does not have valid reverse DNS.
- #
+ #
# This is disabled by default so that DNSless systems don't break. If
# your system can do DNS lookups without delay or cost, you might want
# to enable the following lines.
"""]]
-/etc/exim4/conf.d/acl/40_exim4-config_check_data
+/etc/exim4/conf.d/acl/40_exim4-config_check_data
[[!format txt """
# 40_exim4-config_check_data
# This statement has been added by "greylistd-setup-exim4",
# and can be removed by running "greylistd-setup-exim4 remove".
# Any changes you make here will then be lost.
- #
+ #
# Perform greylisting on incoming messages with no envelope sender here.
# We did not subject these to greylisting after RCPT TO:, because that
# would interfere with remote hosts doing sender callout verifications.
deny message = This message contains malware ($malware_name)
malware = *
-
+
# Always put X-Spam-Score header in the message.
# It looks like this:
"""]]
----
-
- [[CategoryCodeSnippets|CategoryCodeSnippets]] [[CategoryTipsAndTricks|CategoryTipsAndTricks]]
+ [[!tag CategoryCodeSnippets]] [[!tag CategoryTipsAndTricks]]